LM75 mobile column lifts, 7,500kg per column.
Wireless electro-hydraulic column lifts for commercial vehicle workshops. There is nothing to cable, duct or trip over, and the bay stays free for other work when the columns are parked. Buy a set of 2, 4, 6 or 8 and add more columns later as the work changes.


Built for a workshop that keeps moving
Each LM75 column is rated at 7,500kg and works wirelessly, so a set can be wheeled to the vehicle, used and parked out of the way again. The adjustable forks take wheel diameters from 570mm to 1,300mm, so the same columns handle anything from a small minibus to a large tractor unit and trailer.
For a fixed lifting bay, see the full range of commercial vehicle lifts.
Designed for daily commercial workshop use
Every LM75 set is built to the same specification, so extra columns pair into an existing set through the app.
Integral hydraulic trolley
Every column has its own hydraulic trolley for repositioning, engaging under the vehicle and parking.
Adjustable forks
Forks adjust to wheel diameters from 570mm to 1,300mm, supplied as standard on every column.
Mechanical safety latch
A mechanical safety latch with reduced pitch and increased contact width, plus safety valves against overload and pipe rupture.
Obstruction detection
An electro-hydraulic obstruction device interrupts descent if anything is under a platform.
Numbered columns with LED status
Numbered columns with LED status indication, forklift pockets in the base and an IP54 electrical system.
No cables or ducting
The columns are wireless and charge from a standard 230V supply. No groundworks, no floor ducting and no three-phase supply.
Sets of two, four, six or eight columns
Columns are grouped in the app, not wired together. Start with the set you need and add more columns later, pairing them into the existing set on site.
15,000kg combined
One at the front, one at the rear with adapters.
30,000kg combined
Two-axle vehicles.
45,000kg combined
Three-axle vehicles.
60,000kg combined
Four-axle vehicles and trailers.
Motorhomes with recessed wheel arches may need the 150mm fork extension kit, which reduces capacity to 4,000kg per column.
Set the lift and the column layout from the app
A tablet is supplied as standard and arrives set up, ready to go. Columns pair by NFC, with Bluetooth as a second option.
Column status, error codes and a direct link to the relevant manual page are on screen. Operator identity is confirmed by biometric or one-time password, and updates arrive over the air. The app runs on iOS and Android.
Bluetooth as a second option.


Commercial vehicles the LM75 lifts
Two columns lift one axle, four lift a two-axle vehicle, six lift a three-axle vehicle and eight lift a four-axle vehicle.
- Rigids, tractor units and trailers
- Buses, coaches and minibuses
- Agricultural vehicles
- Municipal and refuse vehicles
- Motorhomes
LM75 technical specification
| Drive | Electro-hydraulic |
|---|---|
| Communication | Wireless |
| Capacity per column | 7,500kg |
| Set configurations | 2, 4, 6 or 8 columns |
| Lifting stroke | 1,753mm |
| Lifting time, loaded | 65 sec |
| Lowering time | 54 sec |
| Wheel diameter (adjustable forks) | 570 to 1,300mm |
| Motor per column | 3kW |
| Control tablet | Supplied as standard |
| Electrical supply | 230V, 50 to 60Hz |
| Protection rating | IP54 |
| Column width × depth | 1,107 × 1,307mm |
| Column height | 2,260mm |
| Overall height, fully raised | 3,998mm |
| Weight per column | 640kg |
| Full-height lifts per charge, fully loaded | 14 |
What a set includes
Sets of 2, 4, 6 or 8 wireless 7,500kg columns, adjustable forks as standard, a hydraulic trolley on each column, and a tablet supplied as standard with the setup app ready to go.

Delivered, commissioned and handed over on site
Liftmaster engineers deliver, commission and hand over the columns on site, with operator training included. No groundworks, no ducting and no three-phase supply: the columns charge from a standard 230V supply and complete 14 full-height lifts at full load on a charge. Service and maintenance packages are available, supported by a UK engineering team with parts held in stock.
Installation & servicingCommissioned and handed over by Liftmaster engineers.
Operator training for your team at handover.
Two years parts and labour, third year parts only.
Talk to the Commercial team about LM75 column lifts.
Tell us the vehicles, the number of axles and the workshop. We will recommend the set and provide a quote. Outright purchase and finance options are available.
