QuickJack

8000TLX

QuickJack 8000TLX 3,629kg Portable Car Lift

The BendPak 8000TLX is a 3,629kg portable car lift built for heavy vehicles with long wheelbases. Its extended 1,930mm frames spread from 1,092-1,676mm, reaching the lifting points of trucks, large SUVs and long wheelbase vans. Supplied with four 50mm and four 76mm blocks, it lifts to 622mm stacked.

  • Extended Frames
  • Supplied with 50mm & 76mm Blocks
  • Trucks, SUVs & Long Wheelbase Vans
£1,503.35Excl. VATAvailable for pre-order
1

3,629kg (8,000lb) Capacity With Extended Frames

The 8000TLX pairs the TL range’s 8,000 lb rating with an extended 1,930mm frame length, so heavier vehicles with longer wheelbases can still be raised. It suits trucks, SUVs and larger vehicles that need both the higher capacity and the longer reach.

1,092–1,676mm Lift Point Spread

Extended frames push the lift point spread out to between 1,092mm and 1,676mm, the widest of the three TL-series frames in this range. Longer wheelbase vehicles get properly placed lifting points rather than compromised positioning at the end of the frame.

622mm Lifting Height From an 89mm Profile

The frames lift to 622mm with the stacked blocks in place and sit 89mm above the floor when lowered, so low-clearance vehicles drive over them without ramps. The 622mm height clears the way for wheel, brake and underbody work.

Dual-Position Automatic Safety Locks

Automatic safety locks engage on each frame as it rises and hold the vehicle mechanically while work is carried out underneath. ALI (Automotive Lift Institute) certification covers the frames to recognised industry safety and performance standards.

Four 50mm and Four 76mm Rubber Blocks Included

The bundle ships with four 50mm (2in) medium blocks, four 76mm (3in) tall blocks and two frame-positioning handles. The stackable rubber blocks sit on the frames to suit a wide range of vehicle lift points and protect the contact surfaces.

47kg Frames With Open-Centre Access

Each extended frame weighs 47kg and rolls on urethane wheels, with a detachable hydraulic power unit and no bolted installation. The open-centre design leaves the underside unobstructed during work, unlike ramps or jack stands that block access.

Add to the order

Out of stock

Bendpak

5150006

Price on applicationEnquire for a price
Enquire
Out of stock

Bendpak

5215866

Price on applicationEnquire for a price
Enquire

Other models in the range

QuickJack

8000TL

£1,468.38Excl. VAT

QuickJack

6000TLX

£1,380.98Excl. VAT

QuickJack

6000TL

£1,346.02Excl. VAT